Overview

The build works like this: - We start by running ./autogen.sh - autogen.sh runs autoconf to turn configure.ac into configure - autogen.sh also runs automake to turn Makefile.am into Makefile.in and src/Makefile.am into src/Makefile.in - We then run ./configure - configure turns Makefile.in into Makefile and src/Makefile.in into src/Makefile - configure also turns config.h.in into config.h that contains some variables - configure also writes config.log, if there are errors they will be there

• ALWAYS run ./autogen.sh and ./configure from top-level, never a subdirectory
• ALWAYS configure with --enable-ccache for caching
• ALWAYS configure with --enable-sdfprefs to inhibit noisy build output
• NEVER edit configure directly, only ever edit configure.ac
• NEVER edit Makefile or Makefile.in directly, only ever edit Makefile.am

To change configuration settings, re-run ./configure with new flags.

You can see the existing configuration flags by looking at the head of config.log

Configuration variables

To change compiler from clang to gcc, switch the value you pass for CC and CXX. For example run CXX=g++ CC=gcc ./configure ... to configure with gcc. We want builds to always work with gcc and clang.

To alter compile flags (say turn on or off optimization, or debuginfo) change CXXFLAGS. For example run CXXFLAGS='-O0 -g' ./configure ... to build non-optimized and with debuginfo. Normally you should not have to change these.

Sometimes you will need to change to a different implementation of the C++ standard library. To do this, pass -stdlib=libc++ or -stdlib=libstdc++ in CXXFLAGS explicitly. But again, normally you don't need to do this.

Configuration flags

Here are some common configuration flags you might want to change:

- --disable-tests turns off BUILD_TESTS, which excludes unit tests and all test-support infrastructure from core. We want this build variant to work since it is the one we ship, but it is uncommon when doing development.

- --disable-postgres turns off postgresql backend support in core, leaving only sqlite. tests will run faster, and also this is a configuration we want to work (we will remove postgres entirely someday).

There are also some flags that turn on compile-time instrumentation for different sorts of testing. Turn these on if doing specific diagnostic tests, and/or to check for "anything breaking by accident". If you turn any on, you will need to do a clean build -- the object files will have the wrong content.

- --enable-asan turns on address sanitizer. - --enable-threadsanitizer same, but for thread sanitizer. - --enable-memcheck same, but for memcheck. - --enable-undefinedcheck same, but for undefined-behaviour sanitizer. - --enable-extrachecks turns on C++ stdlib debugging, slows things down. - --enable-fuzz builds core with fuzz instrumentation, plus fuzz targets.

There is more you can learn by reading configure.ac directly but the instructions above ought to suffice for 99% of tasks. Try not to do anything too strange with the configuration.

When in doubt, or if things get stuck, you can always re-run ./autogen.sh and ./configure.